Genuine Leather DIY Car Steering Wheel Cover Anti-slip For Cm Black US

This Genuine Leather DIY Car Steering Wheel Cover gives your steering wheel a fresh black finish with a soft, perforated surface and a hand-stitched look. Designed for a 38 cm (approximately 15-inch) steering wheel, the wrap is sewn around the existing rim rather than simply slipped over it, creating a close-fitting finish when correctly sized and installed.

Key Features

• Genuine cowhide leather:
   The product images identify a soft leather layer with a wear-resistant surface coating.

• Perforated texture:
   Laser-punched perforations support breathability and are designed to help reduce sweat-related slipping.
• DIY hand-stitched fit:
   Sew the edges together around the rim for a tailored appearance.

• Prepared stitching edges:
  The pre-stitched edge lines provide a guide for lacing the cover together.

• Classic black finish:
   Black leather and matching stitching complement a range of car interiors.

Size & Fit

Material: Genuine cowhide leather with a wear-resistant coating, as identified in the product images.
Color: Black.
Intended steering wheel diameter: 38 cm (approximately 15 inches).
Installation: DIY hand stitching using a needle and thread.

Measure the outside diameter of your steering wheel before ordering. Diameter alone does not guarantee compatibility; also check the rim thickness, wheel shape, and spoke arrangement. The installed examples illustrate the wrapping style and are not a guarantee of fit for every vehicle.

How to Install

1. Check the fit first:
    With the vehicle safely parked and the ignition off, position the cover around the steering wheel rim.       Confirm that it fits your wheel before starting to sew.

2. Align the wrap:
    Distribute the leather evenly around the rim. Bring the two stitching edges toward one another along the inside of the wheel, smoothing out twists and folds.

3. Begin the stitching:
    Thread the needle and secure the starting point. Following the illustrated installation sequence, lace between the prepared edge stitches to draw the two sides together.

4. Work around the rim:
    Continue stitching section by section, gently tightening the thread as you go. Keep the tension even so the leather sits closely against the rim without bunching.

5. Finish the seam:
    Secure the thread at the end of each stitched section and tuck away loose ends. Follow the illustrated route around the spokes without covering controls.

6. Inspect before driving:
Check the entire wrap for loose stitching, raised folds, or movement. Do not drive unless the cover is secure and all steering wheel functions remain unobstructed.

General Safety & Care

• Install only while the vehicle is stationary. Keep needles and loose thread away from children and pets.
• Do not cover the airbag area, horn, buttons, or other controls, and do not dismantle the steering wheel or airbag to fit the cover.
• If the cover rotates, slips, or cannot be secured correctly, do not use it while driving. Seek help from a qualified installer if needed.
• Keep the gripping surface clean and dry. Avoid oily dressings or treatments that could leave it slippery.
• Periodically inspect the seam and fit, and stop using the cover if it loosens or becomes damaged.